Mini Wireless Optical Mouse
Instruction Manual
98793 - green
98796 - blue
98794 - pink
For technical support contact Jasco Products at
TABLE OF CONTENTS
1. PACKAGE CONTENTS----------------------4
2. SYSTEM REQUIREMENTS ----------------4
3. SPECIAL MOUSE FUNCTIONS ----------4
4. BATTERY INSTALLATION----------------5
5. HARDWARE INSTALLATION------------6
6. TROUBLE SHOOTING ----------------------8
7. FIVE YEAR LIMITED WARRANTY ----9
8. FCC STATEMENT--------------------------- 10
Page 3
1. Package Contents
•
•
Mini Wireless Optical Mouse
Mini Instruction Manual
•
•
2 AAA Batteries
Mini USB Receiver
2. System Requirements
•
•
•
Windows® 98 SE or higher
Mac OSX 10.1 or higher
Available USB Port
3. Special Mouse Functions
•
The mouse will go to sleep when idle for a long period of
time to save batteries. The mouse automatically wakes upon
movement.
•
When the Low Battery LED (located on the receiver)
changes from green to red, change the batteries.
Page 4
4. Battery Installation
Battery Compartment Cover
PUSH
HERE
PUSH
HERE
Replacing batteries in your GE mini mouse is easy!
1) Simply grip the sides of the mouse and slide the battery cover
back.
2) Replace the old batteries with two AAA batteries
3) Replace the battery cover.
Page 5
Page 6
5. Hardware Installation
Please keep these directions in a safe place.
1) Insert the enclosed batteries into the battery compartment of
your mouse following the directions in Section 4.
2) Plug the Optical Mini Mouse receiver into an available USB
port on your computer or USB hub. It is not necessary to
reboot your computer.
3) If prompted, insert your Windows disk and follow the on
screen instructions. (This step is not necessary for all
operating systems. Your system will prompt you if it is
necessary.)
4) The mouse should auto link requiring no further installation
procedure.
5) In case the auto link feature does not occur, you must
manually link your mouse to your receiver.
6) Press the link button on your receiver.
7) Press the link button on the bottom of your mouse.
8) Your mouse should now function normally. Move your
mouse to test functionality.
Page 7
6. Trouble Shooting
•
The Mini Optical Mouse does not work properly
Optical mice do not work well on glass or highly reflective
surfaces. If this applies to you, try using your mouse on a
different surface.
ꢀ
ꢀ
ꢀ
Re-link your mouse. Press the link button on the receiver.
Press the link button on the bottom of your mouse.
Change the batteries on your mouse. See section 4.
•
Mouse will not move
ꢀ
ꢀ
Re-link your mouse. See section 5.
Sometimes screen savers interfere with the wake feature.
Turn off your screen saver. If the mouse works, try using a
different screen saver.
ꢀ
Change the batteries on your mouse. See section 4.
Page 8
7. Five Year Limited Warranty
Jasco Products Company warrants this product to be free from
manufacturing defects for a period of five years from the original
date of consumer purchase. This warranty is limited to the repair
or replacement of this product only and does not extend to
consequential or incidental damage to other products that may be
used with this unit. This warranty is in lieu of all other warranties
express or implied. Some states do not allow limitations on how
long an implied warranty lasts or permit the exclusion or limitation
of incidental or consequential damages, so the above limitations
may not apply to you. This warranty gives you specific rights, and
you may also have other rights which vary from state to state. If
unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:
Jasco Products Company
10 East Memorial Dr
Oklahoma City, OK 73114
Page 9
8. FCC Statement
Notice: Federal Communications Commission (FCC)
requirements, Part 15
This equipment has been tested and found to comply with the
limits for a class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Page 10
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
•
CAUTION: Any changes of modifications not expressly approved
by the grantee of this device could void the users authority to
operate the equipment. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
is a trademark of the
General Electric Company
and is used under license to
Jasco Products Company LLC,
10 E. Memorial Rd.,
Oklahoma City, OK 73114.
Page 11
|