Genesis Advanced Technologies Stereo System Servo Bass User Manual

Genesis Servo Bass Cable

Owner’s Manual

Rev.1.0

Instructions For Grounding the Shield

On Genesis Servo Cables

Step 1.- Remove the grounding screw from the amplifier chassis. This screw is located on

the rear left hand corner of the chassis bottom.

Figure 1

Step 2. – Using a small piece of 240 grit sandpaper sand the paint around the screw

hole until the chassis metal is exposed.

Figure 2

Figure 3

Step 3. – Using the screw removed in step 1, attach the ring terminal connector on the

Y-cable to the chassis.

Figure 4

Step 4. – Connect the male 1/8” mini jack connector on the ground lead of the left

channel cable pair to one of the female 1/8” mini jack connectors on the Y-

cable.

Figure 5

Step 5. – Connect the male 1/8” mini jack connector on the ground lead of the right

channel servo cable pair to the second female 1/8” mini jack connector on the

Y-cable.

Figure 6